Bag, purse and luggage repair

Carry components are repaired as structural parts, with reinforcement selected for the weight and movement of the bag.

Handle reinforcement
Open and strengthen weak handle interiors or attachment points while preserving usable exterior material when possible.

Handle replacement
Fabricate a compatible replacement handle when the original can no longer carry weight safely.

Strap shortening or lengthening
Adjust compatible straps while preserving balance, hardware placement and a clean finished end.

Crossbody and shoulder strap fabrication
Create a custom strap with selected width, length, attachment and hardware after confirming how the bag will be worn.

Tabs, anchors and attachment points
Rebuild torn tabs or reinforce the body where rings, buckles and handles connect.

High-contact edges often need both cosmetic improvement and structural protection.

Corner repair and rebuilding
Patch, rebuild or cap worn corners according to the depth of damage and desired appearance.

Piping repair or replacement
Repair localized piping damage or replace longer sections when access and construction permit.

Edge paint restoration
Remove unstable finish, prepare the edge and rebuild compatible color layers on handles, straps and panels.

Binding and trim replacement
Replace worn protective trim around openings, seams or high-contact edges.

Wheel work considers the wheel, housing, axle, base and whether replacement parts can carry the expected load.

Wheel replacement
Fit a compatible wheel after measuring diameter, width, axle and available clearance.

Spinner assembly replacement
Replace a compatible multi-directional wheel housing and reinforce its attachment when necessary.

Axle and housing repair
Repair or rebuild the support around a wheel when the rolling part is not the only failure.

Base and corner reinforcement
Strengthen cracked or weakened mounting areas before installing or reattaching rolling hardware.

Handle systems are checked through their full movement and under realistic lifting force.

Telescoping handle replacement
Install a compatible complete pull-handle system when access, dimensions and mounting points allow.

Release button and tube repair
Correct compatible failures in buttons, rods, tubes or locking points without replacing the entire system when practical.

Carry handle reinforcement
Rebuild the handle interior or supporting mount so the case can be lifted safely.

Leather handle fabrication
Create a compatible replacement for traditional trunks, duffles and leather travel pieces.

Travel closures are selected for repeated load and must match the size and direction of the opening.

Slider and pull replacement
Replace compatible sliders or pulls when the zipper chain remains aligned and secure.

Complete luggage zipper replacement
Replace a failed zipper track using a gauge and construction suitable for the case.

Lock and latch repair
Repair or replace compatible case locks, frame latches and supporting mounts.

Opening and seam reinforcement
Strengthen the material surrounding an overloaded closure before reattaching hardware or zipper tape.

• Handles, straps and the structure supporting their attachment points
• Zipper tracks, sliders, closures, locks and available replacement parts
• Wear at corners, piping, edges and the base
• Condition of wheels, wheel housings and telescoping handles
• Lining condition, access for repairs and the way the item carries weight

• The complete item from the front, back, sides and base
• The interior and any lining damage
• Close-ups of the damaged part and its attachment points
• For luggage, the wheels, handle mechanism and maker or model label